300-410考題資訊 - 300-410考古題

從Google Drive中免費下載最新的Testpdf 300-410 PDF版考試題庫：https://drive.google.com/open?id=1r-2JFcaqQ7EG94fTiKCfkdhtiT-U94mK

拿高薪，是每個人的夢想，但究竟能拿多少錢，得由你的職場身價決定。機會很多時候就在你面前.不管你是否喜歡這樣的機會，只有把握住，迎難而上才能獲得非凡的成就。通過 Cisco 認證考試取得一張“金牌派司”無疑是證明和提升自己身價的一個有效方式。Testpdf 300-410 題庫覆蓋了真實的 Cisco 300-410 考試指南，適合全球考生適用。

Cisco 300-410 認證對於尋求增強高級路由和服務技術專業知識的網路專業人士來說是一個有價值的資格。獲得此認證證明了在設計、實施和疑難排解複雜企業網路方面具有高水平的知識和技能，有助於職業晉升和增加就業機會。

>> 300-410考題資訊 <<

Cisco 300-410考古題 & 300-410認證題庫

如果你選擇了Testpdf的幫助，我們一定不遺餘力地幫助你通過考試。而且我們還會為你提供一年的免費的更新考試練習題和答案的售後服務。不用再猶豫了！請選擇Testpdf，它將會是你通過300-410認證考試的最好保證。快將Testpdf加入你的購物車吧！

Cisco 300-410考試對於想在網路工程領域中提升自己職業生涯的IT專業人員而言，是一項有價值的認證。這是一個具有挑戰性的測試，驗證了考生在實施和管理高級路由解決方案、服務和技術方面的知識和技能。通過適當的準備和資源，考生可以成功通過考試，成為企業網絡的認證專家。

Cisco 300-410考試是Cisco認證專家 - 企業高級基礎架構實施認證的一部分，該認證是為希望驗證其在企業網絡中實施高級路由技術和服務技能的IT專業人員而設計的。該考試涵蓋了與企業路由和服務有關的廣泛主題，包括高級路由協議，服務質量（QOS），虛擬專用網絡（VPN）和網絡自動化。

最新的 CCNP Enterprise 300-410 免費考試真題 (Q346-Q351):

問題 #346
Refer to the exhibit.

During troubleshooting it was discovered that the device is not reachable using a secure web browser. What is needed to fix the problem?

A. permit tcp port 22
B. permit tcp port 465
C. permit udp port 465
D. permit tcp port 443

答案：D

問題 #347
Which command is used to check IP SLA when an interface is suspected to receive lots of traffic with options?

A. show track
B. show delay
C. show timer
D. show threshold

答案：A

問題 #348
Refer to the exhibit.

Refer to the exhibit. An engineer applied filter on R1 The interface flapped between R1 and R2 and cleaning the BGP session did not restore the BGP session and failed Which action must the engineer take to restore the BGP session from R2 to R1?

A. Apply the IPv6 traffic filter in the outbound direction on the interface
B. ICMPv6 must be permitted by the IPv6 traffic filter
C. Swap the source and destination IP addresses in the IPv6 traffic filter
D. Enable the BGP session, which went down when the session was cleared.

答案：B

問題 #349
Refer to Exhibit.
A network administrator has successfully configured DMVPN topology between a hub and two spoke routers. Which two configuration commands should establish direct communications between spoke 1 and spoke 2 without going through the hub? (Choose two).

A. At the spoke routers, configure the ip nhrp shortcut command.
B. At the spoke routers, configure the ip nhrp spoke-tunnel command.
C. At the hub router, configure the ip nhrp shortcut command.
D. At the hub router, configure tne Ip nhrp spoke-tunnel command
E. At the hub router, configure ip nhrp redirect the command

答案：A,E

解題說明：
To configure Spoke to Spoke communication we can configure DMVPN Phase II or Phase III. But in Phase II, the first few packets would go through Hub. In order tototally ignore the hub, we have to use DMVPN Phase III:
DMVPN Phase III is same as Phase 2 but removes some restrictions and complexities of Phase 2. Also allows greater variety of DMVPN network designs we use:+ ip nhrp redirect in hub: tells the initiator spoke to look for a better path to the destination spoke than through the Hub. Upon receiving the NHRP redirect message thespokes communicate with each other over the hub and they have their NHRP replies for the NHRP Resolution Requests that they sent out.+ ip nhrp shortcut in spokes: overwrite the CEF table on the spoke. It basically overrides the next-hop value for a remote spoke network from the default initial hubtunnel IP address to the NHRP resolved remote spoke tunnel IP address)

問題 #350
Refer to the exhibit.

Which control plan policy limits BGP traffic that is destined to the CPU to 1 Mbps and ignores BGP traffic that is higher rate?